How old is my massey ferguson tractor manual#

If that's the case, loosen the distributor hold down bolt and rotate the distributor until the rotor points to one of the terminal positions on the cap. If you removed the distributor and have 'lost the timing' then the rotor maybe point between two plug wire locations on the cap. If the rotor revolves in the CCW direction, the next plug wire(#2) will go in the next hole. take off the distributor cap and see what position on the cap the rotor is pointing at. Now you know that the #1 piston is at the static firing point. Now using the timing marks get the #1 piston to the timing mark by bumping the starter. You need to find the compression stroke on # 1 cylinder so hold your thumb over the spark plug hole on the #1 cylinder and bump the starter till you feel pressure on your thumb. Remove the spark plugs, and locate the timing mark.

Since you removed the plug wires and don't know where the engine is in its firing order you'll have to re-time it. Thank you in advance for your assistance,

I know it is over kill, but when I go out to the farm and fire that baby up I want her to run the best she can. Due to the overheated wiring harness I decided to replace everything and be done with it. I have on order a new Coil, Distributor Cap, Condenser, Points, Wires, and Plugs. I am getting juice to the Distributor Cap, but no spark. God bless that man I am a good mechanic, but I will never have the skills that he has. Very healthy, but fighting a disease that is frustrating to him and everyone around him. I ask my Dad the order of the plug wires. I was plugging everything back together until I can order parts. He popped the Distributor Cap off and performed field testing and diagnosed that we should replace the Condenser. He knows what he is doing, but he cannot remember what he has done. My father is (was a master shade tree farm mechanic). After I got the MF 135 rewired (Except the non-Amp Meter wiring) and a Starter Solenoid I still had no fire. In my previous post I told the story about a sort has melted the wiring harness and my Dadз—ґ Alzheimerз—ґ. If this is true, then #2 is in the middle, and #3 is on the bottom right. I think #1 is the top left of the Distributor Cap. I think number cylinder #1 is close to the radiator (am I right). lb) at 1,100 rpmДЇorward: 18.5 kmh (11.5 mph) Reverse: 5.4 (3.I need assistance with the order of Spark Plug Wires to Distributor Cap?.gal) fuel tank.ДЇerguson TO-30 Specifications General SpecificationsДЎ45.1 N

How old is my massey ferguson tractor manual#

The Ferguson TO-30 is equipped with manual steering, differential mechanical expanding shoe brakes, open operator station, and 38.0 liters (10 US gal. This engine produced 31.4 PS (23.1 kW 31.0 HP) at 2,000 rpm of output power. in) four-cylinder natural aspirated gasoline engine with 83.0 mm (3.27 in) of the cylinder bore and 98.0 mm (3.86 in) of the piston stroke.The Ferguson TO30 utility tractor used the Continental Z-129 engine. in) four-cylinder gasoline engine and unsynchronized gear transmission with 4 forward and 1 reverse gear.The Ferguson TO-30 is equipped with a 2.1 L (129.0 cu This tractor was manufactured by Ferguson in Detroit, Michigan, USA from 1951 to 1954. The Ferguson TO-30 is a 2WD utility tractor from the series.